Perun Moto Billet Rack suits 2021 KTM1290

Additional spacers for removing passenger grab handles included!

• Low profile - due to unique 3D milled angled spacer platforms and angled countersunk holes, rack sits low, close to the tail plastics and at the same angle as the stock seat;
• Customizable - it can be used with our without stock grab handles; three different height options so it can perfectly support different luggage options,
• Supports stock grab handles - rack sits directly above stock grab handles, providing adequate support when grab handles are being pulled upwards,
• Twenty six slots - strapping points for all kind of soft luggage, tool bags or roll bags, slots for perfect Mosko moto Reckless 80 mounting,
• Adequate top surface - approx. 30/20 (W) x 31.5 (L) cm of completely flat top surface, perfect for 10-30 liter soft bags,
• Strap-friendly -  chamfered, smooth edges,
• Strong and durable - milled out of aluminum-magnesium alloy, attached to the bike using M8 bolts,
• Lightweight - less than 1 kg, weights less than stock rear rack,
• Givi/Kappa Monokey top case ready - pre-drilled holes for Givi adapter kit (not included - check instructions for details) - limited compatibility with plastic Givi Trekker cases - email for details,
• SW-motech top case ready - pre-drilled holes for SW-Motech adapter kit (not included - check instructions for details),
• Rotopax ready - pre-drilled holes for Rotopax mount (mount not included), for 1 gallon Rotopax fuel or water can,
• Kriega OS-Rack Loops ready - pre-drilled and chamfered holes for Kriega OS-rack loops, for perfect mounting of Kriega bags, 
• Future proof - marked holes for upcoming KTM luggage options,
• All necessary hardware provided - high quality 10.9 zinc coated bolts and powder coated spacers,
• High quality powder coat - matte black powder coat (top of the line IGP Duraface powders).

Contents;

Content of the hardware kit

• 1 x 1290 Billet top rack,
• 2 x 8 mm spacer,
• 4 x 13 mm spacer,
• 2 x 25 mm spacer,
• 2 x 29 mm spacer,
• 2 x M8x40 countersunk bolt,
• 2 x M8x50 countersunk bolt,
• 2 x M8x60 countersunk bolt.

Rack can be installed with our without stock grab handles. Three combinations are shown below, as well as several other options. 

I. 1290 Billet top rack with stock grab handles

II. 1290 Billet top rack without stock grab handles - high position

III. 1290 Billet top rack without stock grab handles - low position

IV. Installation of Givi Monokey top box

V. Installation of SW-Motech top box

VI. Rotopax installation